
We build and repair decks around Las Cruces, from small platforms to full two-story setups with stairs and rail systems. Most of us ended up in this trade because we like outdoor work and a project you can actually see finished by the end of the week.
If you called us about a deck that's sagging in the middle or boards that have gone gray and cupped, that usually comes down to spacing, drainage, or a ledger board that was never flashed right. We re-flash the ledger, check that the footings are still solid below the frost line, and replace joists before we touch the decking on top. Fixing the surface without fixing what's underneath just buys you another year or two.
None of this is complicated. It is mostly just doing what we said we would do.
You're covered if something goes wrong on site, and proof of insurance is available before work starts. That matters more on a deck than people think, since most of the work involves ladders, power tools, and sometimes a second story.
Doña Ana County requires a permit for most elevated decks, and skipping that step can cause problems when you sell the house. We handle the paperwork and the inspection ourselves.
Deck demo and framing leaves a lot of scrap wood and loose fasteners behind. We bag it up and haul it out at the end of each day, not just at the end of the job.
Lumber, joist hangers and fasteners, and labor get priced separately, so you can see where the money's going. No surprise add-ons once the framing is open.
We don't hand the job off between a framing crew and a finish crew. The people who set your footings are the same ones putting down the decking boards.
We've seen what UV does to untreated cedar here and what a hard monsoon storm does to a deck with bad drainage. That shapes the materials and details we recommend.
Framing, railing, and finish work from recent deck projects.



Questions about who's doing the work and how to check it.
Free estimate, a price in writing, and work we stand behind.